What cutting equipment should a sheet metal processing factory have?​

Cutting equipment in sheet metal processing factories, including base, cutting and other industries, cutting motor, clamping mechanism, maglev drive management system, etc., the base is equipped with a bearing beam, the drive management system of the maglev bearing beam is located on the upper part, and the maglev engine or management system and Cutting and welding, reducing the movement of the load-bearing beam driven by the engine, the cutting industry base is located in the middle, the clamping mechanism includes four clamping mechanisms, the four clamping mechanism departments are located on the four edge industries of the cutting industry, reducing damage to the industrial sectors on both sides of the post, organization There is a blanking box, both sides of the base near the cutting industry sector are equipped with air pumps, and two air pumps are equipped with sharp corners for blowing, which is suitable for the new magnetic levitation drive management system drive to reduce the movement of the engine support beam outside, which can stabilize the sheet metal processing plant, and then develop cut quality.
What cutting equipment should a sheet metal processing factory have?
Newly affects the technical field of mechanical equipment, especially the fast and accurate CNC bending machines in sheet metal processing plants positioning and installation. After the negotiation of the impact of the two sets of positioning plates, we can do a part-time job to distinguish the impact of the working plate and the lower mold, so that the lower mold and the lower mold can be fully driven. At the same time, the overall bearing capacity of the lower mold and the lower mold can be uniform, and the application range and reliability can be developed; including the seat, the lower mold, the blank, 2 sets of abutments, on-site casting, 2 hydraulic installations, the seat and the lower mold remain unchanged, The top of the seat and the bottom of the lower mold remain unchanged, the right version is the same, the lower left corner of the bottom seat and the top outer and back of the bottom version and the 2 sets of bottom abutments remain unchanged, and the two sets of top divisions are cast on the outside of the bottom abutment Same as the back; also includes moving plate, 2 sets of slide rails, 4 sets of rollers, second moving plate, moving nut, motor, reducer and transmission shaft.